blob: 579977ae11baca81cbcc2058eec03942ca8361f3 (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
|
#define BOARD_NAME "STM32 Primer2"
#define BOARD_ID 0x21e5798d
#define STM32_PLLXTPRE STM32_PLLXTPRE_DIV1
#define STM32_PLLMUL_VALUE 6
#define STM32_HSECLK 12000000
#define GPIO_LED_BASE GPIOE_BASE
#define GPIO_LED_SET_TO_EMIT 0
#define GPIO_USB_BASE GPIOD_BASE
#define GPIO_USB_CLEAR_TO_ENABLE 3
#define GPIO_OTHER_BASE GPIOA_BASE
/*
* Port A setup.
* PA0 - input with pull-up. AN0
* PA1 - input with pull-up. AN1
* PA8 - Input with pull-down (PBUTTON).
* PA11 - Push Pull output 10MHz 0 default (until USB enabled) (USBDM)
* PA12 - Push Pull output 10MHz 0 default (until USB enabled) (USBDP)
* ------------------------ Default
* PAx - input with pull-up
*/
#define VAL_GPIO_OTHER_ODR 0xFFFFE6FF
#define VAL_GPIO_OTHER_CRL 0x88888888 /* PA7...PA0 */
#define VAL_GPIO_OTHER_CRH 0x88811888 /* PA15...PA8 */
/*
* Port D setup.
* PD3 - Push pull output 50MHz (USB 1:ON 0:OFF)
* ------------------------ Default
* PDx - input with pull-up
*/
#define VAL_GPIO_USB_ODR 0xFFFFFFFF
#define VAL_GPIO_USB_CRL 0x88883888 /* PD7...PD0 */
#define VAL_GPIO_USB_CRH 0x88888888 /* PD15...PD8 */
/*
* Port E setup.
* PE0 - Push pull output (LED 1:ON 0:OFF)
* PE1 - Push pull output (LED 1:ON 0:OFF)
* PE3 - Input with pull-down (JOYSTICK L).
* PE4 - Input with pull-down (JOYSTICK R).
* PE5 - Input with pull-down (JOYSTICK U).
* PE6 - Input with pull-down (JOYSTICK D).
* ------------------------ Default
* PEx - input with pull-up
*/
#define VAL_GPIO_LED_ODR 0xFFFFFF87
#define VAL_GPIO_LED_CRL 0x88888833 /* PE7...PE0 */
#define VAL_GPIO_LED_CRH 0x88888888 /* PE15...PE8 */
#define RCC_ENR_IOP_EN \
(RCC_APB2ENR_IOPAEN | RCC_APB2ENR_IOPDEN | RCC_APB2ENR_IOPEEN)
#define RCC_RSTR_IOP_RST \
(RCC_APB2RSTR_IOPARST | RCC_APB2RSTR_IOPDRST | RCC_APB2RSTR_IOPERST)
|
